Broilmaster SS26P-1, DCB1-2, SS48G-1, PCB1-2, BL26P-1, BL48G-1, B101652, B101586-4-0112 Cart Assembly

Cart Assembly

5.Attach Rear Brace to the Left and Right Side Assemblies with two 1/4-20 x 3/4” Phillips Truss Head screws and 1/4-20 Hex nuts. See Figure 5. Important: Make sure the brace goes in the cutout of the support bracket.

Figure 5

6.Insert bushing in the front panel on the right for P and H series and on the left for R and T series grills. Install rubber guard over cart cut out. See Figure 6.

Figure 6

Note: Bushing is used to protect the ignitor wires from rubbing on the front panel when they are in place.

Note: Ignitor wires must go through the bushing before grill head is fully installed.

7.Secure the grill head to the cart using four 1/4-20 x 3/4” Hex Head Bolts and 1/4 x 5/8 Flat Washers. See Figure 7. Note:

To ease assembly, you may wish to install the ignitor as shown in your Broilmaster® grill manual before attaching the grill to the cart.

Figure 7

8.Attach the Heat Shield to the Left and Right side assemblies with two 1/4-20 x 3/4 Phillips Truss Head screws and 1/4-20 Hex nuts. Make sure shield is resting on the cutout provided in the side panels before tightening the screws and nuts. See Figures 8 and 9. Note: Grill head removed for clarity.

Figure 8

B101586-4-0112 Figure 9 Page 9