Broilmaster DCB1-2, SS26P-1, SS48G-1, PCB1-2, BL26P-1, BL48G-1, B101652, B101586-4-0112 Cart Assembly

Cart Assembly

Caution: Be careful when handling parts, as they may contain sharp edges. Work gloves are recommended to prevent injury. Remove protective plastic covering.

1.For Stationary Cart Assembly: Use the template on page 23 to locate and pre-drill the three screw holes into wood or concrete for the cart base. If applicable, drill the 1 1/2” gas line access hole. DO NOT secure base with the screws at this time. For Mobile Cart Assembly: Flip plastic base and insert casters by inserting the pin provided with the casters in the proper hole. It is recommended that the two casters with brakes should be in the front of the base. See Figure 1.

Figure 1

2.Place the base support brackets on the side panels. Slide the short flanges on the brackets between the top and side flanges of the side panels. See Figure 2.

Figure 2

Page 8

3.Align the holes on the front and side panel assemblies and secure with six #10-24 x 1/2” Phillips screws and 10-24 Keps Nuts provided (3 on each side). Do not tighten these screws until all are installed. Use black screws for black carts and stainless steel screws for stainless steel carts. See Figures 2 and 3.

Figure 3

4.Secure the completed assembly to the base with four 1/4-20 x 3/4” Phillips Truss screws. See Figure 4. Note: Plastic base comes with factory installed threaded inserts. Install all four screws before tightening.

Figure 4

B101586-4-0112