Error Message | Cause |
| Remedy |
|
|
|
|
|
|
INTERFACE | This message appears if the wrong | Windows |
|
|
ERROR! | port is selected. | Under “Print to the following | ||
|
| port” in the printer Properties | ||
|
| dialog box, select “PTUSB:” for | ||
|
| the USB connection. |
| |
|
| ☞ If two or more of the same | ||
|
| |||
|
| nected | through their | USB |
|
| ports, instead of “PTUSB:”, | ||
|
| select | “PTUSB | (PT- |
|
| |||
|
| (where XXXXXXXXX is the | ||
|
| serial number). The serial | ||
|
| number is written above the | ||
|
| barcode on the silver label | ||
|
| attached to the bottom of | ||
|
| the |
| |
|
| Macintosh |
|
|
|
| In the Chooser, select the PT- | ||
|
| 2600/2610 as the printer. |
| |
|
|
| ||
LENGTH | • This message appears if the text is | • Shorten the text to less than 3’ | ||
LIMIT! | longer than 3’ 3 1/3” (1 meter) when | 3 1/3” (1 meter) before trying | ||
| you try to print. | to print. |
|
|
|
|
| ||
| • This message appears if the Length | • Set the label length between | ||
| function is used to set a label | 1.6” (4.0 cm) and 11.8” (30.0 | ||
| length that is less than 1.6” (4.0 | cm). |
|
|
| cm) or more than 11.8” (30.0 cm). |
|
|
|
|
|
| ||
| • This message appears if the Tab | • Set the tab length so that it is | ||
| Length function is used to set a tab | less than 11.8” (30.0 cm). |
| |
| length that is more than 11.8” |
|
|
|
| (30.0 cm). |
|
|
|
|
|
| ||
LINE | This message appears if the number | Reduce the number of lines or | ||
LIMIT! | of lines in the text is greater than the | install a tape of greater width. | ||
| maximum number of lines possible |
|
|
|
| for the installed tape. |
|
|
|
|
|
| ||
MEMORY | This message appears if you try to | Delete an unwanted file to make | ||
FULL! | store a text file after the maximum | room for the new one. |
| |
| number of characters has already |
|
|
|
| been stored in the memory. |
|
|
|
|
|
|
|
|
110