Starting/Ending Position Settings 123

——
————————————————————————————————————————————————————————————
—
——————————————————————
4
Starting/Ending Position Settings
The machine can set the start point and the ending point separately from the 9 points of the pattern. Those
are upper-left corner, upper-center, upper-right corner, center-left, center-center, center-right, lower-left
corner, lower-center and lower-right corner.
These settings can be used to repeatedly sew a pattern along a diagonal.
The starting/ending position settings are specified
from the embroidering settings screen.
When the embroidery machine is purchased, both
the starting position and the ending positions are
set to the center of the pattern.
1Touch .
XThe starting/ending position settings
screen appears.
1Specifies the starting position
2Specifies the ending position
Touch a key to select the setting.
The highlighted key shows the currently
selected setting.
Example
3Touch this key to close this screen.
■Specifying the starting position
2Touch the key for the desired starting
position setting.
XWhen a starting position is selected, the
ending position is automatically set to the
same position.
XThe embroidery frame moves to the
starting position.
■Specifying the ending position
3Touch the key for the desired ending
position setting.
4After selecting the desired settings, touch
.
XThe embroidering settings screen appears
again.
Memo
●The starting/ending position settings do
not change until the key for a new setting
is touched. The settings specified before
the machine is turned off remain selected
the next time that the machine is turned
on.
This key is selected.
1
2
3