Brother computerized embroidery and sewing machine Such a case, start from n again

————————————————————————————————————————————————————

pLower the needle threader lever on the left side of the machine as much as possible to make the hook turn.

a

aNeedle threader lever

Ta

Tb

aNeedle

bHook

Note

zIf the needle threader lever is not lowered as much as possible, the hook will not turn fully as shown below and the thread will not pass through the eye of the needle.

In such a case, start from n again.

zIf the needle is not raised, the needle threader cannot thread the needle. Be sure

to press (Needle position button) to raise the needle before using the needle threader. For details, refer to step c of "Threading the upper thread" (page 32).

qRaise the needle threader lever slowly. Ta

1

aNeedle threader lever

rRaise the presser foot lever, and carefully pull the loop of the thread through the eye of the needle to pull out the end of the thread.

CAUTION

●Do not touch a button. Do not touch the start/stop button, needle position button or reverse/reinforcement stitch button. If one of the buttons is accidentally pressed, the machine will begin sewing and your finger may be pricked with the needle or the needle may break.

●When pulling out the thread, do not pull it with extreme force, otherwise the needle may bend or break.

sPass the end of the thread through the presser foot, and then pull out about 5 cm (2 inches) of thread toward the rear of the machine.

a

a5cm (2 inches)

XThe upper threading is finished.

Upper Threading 35