GETTING READY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
20
dInsert the bobbin into the shuttle so that the
thread unrolls to the left.
• Be sure to insert the bobbin correctly.
CAUTION
Memo
zThe order that the bobbin thread should be
passed through the shuttle is indicated by
marks around the shuttle. Be sure to thread
the machine as indicated.
eLightly hold down the bobbin with your right
hand, and then guide the thread as shown with
your left hand.
fPass the thread through the slot as shown, and
then pull the thread out toward the front.
aCutter
XThe cutter cuts the thread.
• Make sure that the thread is correctly inserted
through the tension-adjusting spring of the
shuttle. If it is not inserted, re-insert the
thread.
aTension-adjusting spring
gReattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.
XThe bobbin threading is finished.
Next, thread the upper thread. Continue with
the procedure in "Upper Threading" (on the
next page).
Memo
zYou can begin sewing without pulling up the
bobbin thread. If you wish to pull up the
bobbin thread before starting to sew, pull up
the thread according to the procedure in
"Pulling up the bobbin thread" (page 31).
●Be sure to hold down the bobbin with your finger and unroll the bobbin thread correctly, otherwise the thread may break or the thread tension will be incorrect.
1
1
2
1