Cover C

Needle and presser foot section
aButtonhole lever
Lower the buttonhole lever when sewing buttonholes
and bar tacks.
bNeedle bar thread hooks
Pass the upper thread through the needle bar thread
hooks.
cNeedle plate
The needle plate is marked with guides for sewing
straight seams.
dBobbin cover/Shuttle
Remove the bobbin cover, and then insert the bobbin
into the shuttle.
eFeed dogs
The feed dogs feed the fabric in the sewing direction.
fPresser foot
The presser foot applies pressure consistently on the
fabric as the sewing takes place. Attach the appropriate
presser foot for the selected stitching.
gPresser foot holder
The presser foot is installed onto the presser foot holder.
Right-side/rear view
aHandle
Carry the sewing machine by its handle when
transporting the machine.
bBalance wheel
Turn the balance wheel toward you to raise and lower
the needle to sew one stitch.
cEmbroidery card slot
Insert the embroidery card.
dMain power switch
Use the main power switch to turn th e sewing machine
on and off.
ePower supply jack
Insert the plug on the power supply cord into the power
supply jack.
fFoot controller jack
Insert the plug on the end of the foot controller cable
into the foot controller jack.
gAir vent
The air vent allows the air surrounding the motor to be
exchanged. Do not cover the air vent while the s ewing
machine is being used.
hFeed dog position switch
Use the feed dog position switch to lower the f eed dogs.
Memo

zRefer to Cover B, C, D or E pages while you

are learning to use your machine.

12
3
4
5
6
7
1
2
4
6
3
7
5
8