GETTING READY
dLower the needle threader lever on the left side of the machine until it clicks, and then slowly return the lever to its original position.
1
aNeedle threader lever
XThe thread is passed through the eye of the needle.
Note
zIf the needle was not completely threaded, but a loop in the thread was formed in the eye of the needle, carefully pull the loop through the eye of the needle to pull out the end of the thread.
CAUTION
●When pulling out the thread, do not pull it with extreme force, otherwise the needle may break or bend.
eRaise the presser foot lever, pass the end of the thread through the presser foot, and then pull out about 5 cm (2 inches) of thread toward the rear of the machine.
1
a5 cm (2 inches)
XThe upper threading is finished.
Now that the upper threading and the lower threading are finished, you are ready to begin sewing.
Note
zIf the needle is not raised, the needle threader cannot thread the needle. Be sure
to press 
(“Needle Position” button) to raise the needle before using the needle threader.
32