Reset
The following reset functions are available:
1Network
You can reset the print server back to its default factory settings such as the password and IP address information.
2All Settings
You can reset all the machine settings back to the settings that were set at the factory.
Brother strongly recommends you use this operation when you dispose of the machine.
Note
Unplug the interface cable when you reset All Settings.
How to reset
a
b Press a or b to choose 1.Network or
2.All Settings. Press OK.
c Press a or b to choose 1.Reset or
2.Exit. Press OK.
d If you chose 1.Reset in step c, you will be asked to reboot the machine. Press a or b to choose 1.Yes or 2.No. Press OK.
If you choose 1.Yes, the machine will begin the Restart.
Note
You can also reset the Network settings by pressing Menu, 5, 0.
102
Packing and shipping the machine
CAUTION
Make sure that the machine has fully cooled down by leaving it disconnected from the power for at least 30 minutes before packing.
When you transport the machine, use the packing materials that came with your machine. If you do not pack the machine correctly, you could void your warranty.
a Turn off the machine.
b Unplug all the cables and AC power cord from the machine.
c Push the Scanner Lock Lever down to lock the scanner. This lever is located on the left of the scanner glass.
IMPORTANT
Damage caused to your machine by failure to lock the scanner before packing and shipping may void your warranty.
d Press the front cover release button and open the front cover.
e Take out the drum unit and toner cartridge assembly. Leave the toner cartridge installed in the drum unit.