Brother FAX-1030E, FAX-1020E manual 67

Remote Commands

Follow the commands below to access features remotely. When you call the fax machine and enter your Remote Access Code (1 5 9 ), the system will signal you with two short beeps to enter a remote control command.

Remote control commands			Detail Operation
95 Change Fax Forwarding
Setting
	1	OFF	If you hear one long beep, the change is accepted. If you hear
			three short beeps, you cannot change it because the
	2	Fax forwarding
			conditions (ex. registering fax forwarding) have not been
	4	FAX FWD No.
			completed. You can register your fax forwarding number by
			using 4.FAX FWD NO. Once you have registered the
			number, the machine will automatically turn to “FAX
			FWD:ON” mode. Then, receive a Memory Status List by
				ADVANCED
			entering 961. Check the List to make sure the Fax
			Forwarding number you registered is correct. Now the
			machine will start Fax Forwarding.
	6	FAX STORAGE ON	You can set FAX STORAGE ON or OFF. (Switching Fax	USE
			Storage OFF is only possible if there are no faxes stored in
	7	FAX STORAGE OFF
			the memory, or if all faxes have been erased using Remote
			Control 9 6 3.)
96 Retrieve FAX
	1	Memory Status List	You must use a remote fax machine in order to receive a List
			of stored fax message(s).
	2	Retrieve all FAX
	3	Erase FAX in the	If you hear one long beep, you can erase fax message(s) from
		memory	the memory.
97 Check the receiving status			You can check whether your fax machine has received any
			fax message(s). If yes, you will hear one long beep. If no, you
	1	DOC
			will hear three short beeps.
98 Change Answer Mode			If you hear one long beep, you can change the answer mode.
			If you hear three short beeps, you cannot change it.
	1	TAD
			(Example: There is no TAD MSG when you want to change
	2	F/T
			to TAD mode.)
	3	FAX
90 Exit			After a long beep, you can exit remote control.

Remote Fax Options (Only for FAX-1020e) 60