USER’S GUIDE

9.Retain the cover plate and two screws removed in Step 2 in case you want to remove the MIO card later.

Fig. 5-72 Installing the MIO Card

RAM Expansion

This printer has 64 Mbytes of memory standard and 2 slots for optional expansion memory. The memory can be expanded up to 320 Mbytes by installing commercially available dual in-line memory modules (DIMMs). (The standard memory fitted can vary depending on the printer model and country.)

This printer uses memory module which is:

100 pins, no-parity, SDRAM with 64Mbit or more.

This printer is not compatible with Extended Data Output (EDO) DIMM, or DIMM which uses 16Mbit SDRAM.

The following capacity of DIMM can be installed:

• 16 Mbyte

TECHWORKS

PM-HP 16M-BR

• 32 Mbyte

TECHWORKS

PM-HP 32M-BR

•

64 Mbyte

TECHWORKS

PM-HP 64M-BR

•

128 Mbyte

TECHWORKS

PM-HP 128M-BR

In general, the DIMM must have the following specifications:

Type:

100 pin and 32 bit output

CAS Latency: 2 or 3

Clock Frequency: 66Mhz or more

Capacity:

16,32, 64 or 128 Mbyte

Height:

46mm (1.8 inches) or less

Parity:

NONE

Dram Type: 64 M bit SDRAM 4 Bank

SDRAM can be used.

✒Notes

∙There might be some DIMMs which will not work with this printer.

∙For more informationabout the memory cards consult the dealer where you purchased the printer.

∙For the latest information: http://www.brother.com

5-56