Packing and shipping the machine

When you transport the machine, use the packing materials that came with your machine. If you do not pack the machine properly, any damage that may occur in transit will not be covered by your warranty.

CAUTION

Troubleshooting and Routine Maintenance

CAUTION

Make sure that the plastic tabs on both sides of the green protective part (1) have securely clicked into place (2).

It is important to allow the machine to ‘park’ the print head after a print job. Listen carefully to the machine before unplugging it to make sure that all mechanical noise has stopped. Not allowing the machine to finish this parking process may lead to print problems and possible damage to the print

1

2

head.

a Open the ink cartridge cover.

b Press the lock release lever to release the ink cartridge and take out all the ink cartridges. (See Replacing the ink cartridges on page 111.)

c Install the green protective part, and then close the ink cartridge cover.

If you are not able to find the green protective part, DO NOT remove the ink cartridges before shipping. It is essential that the machine be shipped with either the green protective part or the ink cartridges in position. Shipping without them will cause damage to your machine and may void your warranty.

d Unplug the machine from the telephone wall jack and take the telephone line cord out of the machine.

e Unplug the machine from the AC power outlet.

f Using both hands, use the plastic tabs on both sides of the machine to lift the scanner cover until it locks securely into the open position. Then unplug the interface cable from the machine, if it is

connected.

B

119