Hang up.
Press Remote Access.

Remote Retrieval (MFC-J625DW only)

You can call your machine from any touch-tone telephone or fax machine and then use the remote access code and remote commands to retrieve fax messages.

Setting a Remote Access Code

The Remote Access Code lets you access the remote retrieval features when you are away from your machine. Before you can use the remote access and retrieval features, you have to set up your own code. The factory default code is the inactive code (---).

a Press Menu.

b Press s or t to display Fax. c Press Fax.

d Press s or t to display

Remote Access.

e

f Enter a three-digit code using numbers 0-9, l, or # by pressing the buttons on the screen.

Press OK.

(The preset ‘l’ cannot be changed.)

Note

Do not use the same code as your Fax Receive Code (l 5 1) or Telephone Answer Code (# 5 1).

(uuBasic User’s Guide: Using external and extension telephones)

g Press Stop/Exit.

Receiving a fax

Note

You can change your code at any time by entering a new one. If you want to make

your code inactive, press in step f to restore the inactive setting (---l) and press OK.

Using your Remote AccessCode4

a Dial your fax number from a touch-tone telephone or another fax machine.

b When your machine answers, enter your remote access code (3 digits followed by ) at once.

c The machine signals if it has received messages:

1 long beep — Fax messages

No beeps — No messages

d When the machine gives two short beeps, enter a command.

The machine will hang up if you wait longer than 30 seconds to enter a command.

The machine will beep three times if you enter an invalid command.

e Press 9 0 to stop Remote Access when you have finished.

f

Note

If your machine is set to Manual mode and you want to use the remote retrieval features, wait for about 100 seconds after it starts ringing, and then enter the remote access code within 30 seconds.

21