Threading the needle

(using the needle threader)

The needle can be threaded by one-touch operation using the needle threader.

1.Lower the presser foot lever 1 to lower the presser foot.

1

2.Pull the end of the thread, which has been passed through the needle bar thread guide

2, to the left, then pass the thread through the notch of the thread guide 3, and then firmly pull the thread from the front and insert it into the slit of the thread guide disk 4 all the way.

NOTE:

Make sure that the thread passes the notch of the thread guide 3.

2

4

3

3.Cut the thread with the thread cutter 5 on the left side of the machine.

5

4.Lower the needle threader lever 6 on the left side of the machine as much as possible.

6

The thread passes through the eye of the needle.

5.Release the needle threader lever 6.

6.Carefully pull the loop of the thread through the eye of the needle to pull out the end of the thread.

7.Raise the presser foot lever 1, then pass the end of the thread through the presser foot, and then pull out about 5 cm (2 inches) of thread toward the rear of the machine.

5cm

18