Brother XL-2620i, XL-2610i Changing the Presser Foot, Touches the stopper, and securely tighten

4Hold the needle with your left hand, and then use a coin or screwdriver to turn the needle clamp screw counterclockwise to remove the needle.

1Use a coin or screwdriver

2 Needle clamp screw

•Do not use excessive force when loosening or tightening the needle clamp screw, otherwise certain parts of the sewing machine may be damaged.

5With the flat side of the needle toward the back of the machine, insert the needle until it touches the needle stopper. Next, tighten the needle clamp using a coin or screwdriver.

1Use a coin or screwdriver

2 Needle Stopper

3 Needle

Put the twin needle in the same way.

CAUTION

●Make sure you insert the needle until it

touches the stopper, and securely tighten	1
the needle clamp screw with a coin or
screwdriver. If the needle is not fully
inserted, or if the needle clamp screw is
loose, the needle may break or the
machine may be damaged.

Changing the Presser Foot

CAUTION

●Always turn off the power before you change the presser foot. If you leave the power on and step on the controller, the machine will start and you may be injured.

●Always use the correct presser foot for the stitch pattern you have chosen. If you use the wrong presser foot, the needle may strike the presser foot and bend or break, and may cause injury.

●Only use presser feet that have been designed to be used with this machine. Using any other presser foot may cause accident or injury.

You will have to change the presser foot depending on what you want to sew and how.

■Snap-on Type

1Raise the needle to its highest position by turning the handwheel toward you (counterclockwise), and then raise the presser foot lever.

2Press the black button at the back of the presser foot holder to release the presser foot.

1Black button

2Presser foot holder

3 Presser Foot

9