Brother XL-3510i Main Power and Sewing Light Switch, Foot Controller, Checking the Needle

KNOWING YOUR SEWING MACHINE —————————————————————————————————————————

Main Power and Sewing

Light Switch

This switch turns the main power and sewing light on or off.

1

2

1Turn on (toward the ‘I’ mark)

2 Turn off (toward the ‘O’ mark)

Foot Controller

When you press the foot controller down lightly, the machine will run at a low speed. When you press harder, the machine’s speed will increase. When you take your foot off the foot controller, the machine will stop. You should make sure that nothing is placed on the foot controller when the machine is not in use.

1

1Foot controller

CAUTION

●Do not allow pieces of cloth and dust to build up on the foot controller. Doing so could cause a fire or an electric shock.

Note

(For U.S.A. only)

●Foot Controller: Model KD-1902

This foot controller can be used on the following machine models:

XL-3500, XL-3500i XL-2600, XL-2600i XL-3510, XL-3510i XL-2610, XL-2610i XL-3520, XL-3520i XL-2620, XL-2620i

Checking the Needle

The sewing needle must always be straight and sharp for smooth sewing.

■Checking the Needle Correctly

Put the flat side of the needle on a flat surface. Check the needle from the top and the sides. Dispose of any bent needles safely.

1

2

1Parallel space

2Level surface (bobbin cover, glass, etc.)

Replacing the Needle

CAUTION

●Turn the main power switch off before you change the needle. If you leave the main power on and step on the foot controller, the machine will start and you may be injured.

●Only use sewing machine needles for home use. Other needles may bend or break and cause injury.

●Never sew with a bent needle. A bent needle will easily break and cause injury.

1Remove the power supply plug from the outlet.

2Raise the needle to its highest position by turning the handwheel toward you (counterclockwise) so that the mark on the handwheel points directly up.

3Lower the presser foot lever.

1

1Presser foot lever

8