Power Supply, Adaptors and Drop-in Tray Charger | Motorola XTNI

Power Supply, Adaptors and Drop-in Tray Charger

Power Supply

Drop-in Tray Charger

Your radio comes with one Drop-in Tray Charger, one Power Supply (also known as Transformer) and a set of adaptors.

Your power supply, has a ‘switchable’ capability which allows to suit any of the adaptors that comes with your radio package. The adaptor you should choose to install depends on the region you're located.

Once you have identified the adaptor that matches your electrical outlet, proceed to install it as follows:

Adaptor	CHARGERS	BATTERIESAND
Adaptor
Adaptor

Power Supply

Power Supply

InstallRemove

•Slide down the adaptor grooves into the power supply until it snaps into place.

•Slide the adaptor upward to remove.

Note: The adaptor shown in the pictures are just for illustration purposes. The adaptor you should install may be different.

15 English

Image 17

Motorola XTNI manual Power Supply, Adaptors and Drop-in Tray Charger

Contents

Page Page Contents Hands Free without Accessories iVOX30 Contents Accessories Computer Software Copyrights Computer Software Copyrights Safety Safety Batteries and Chargers Safety Information Batteries and Chargers Safety Information Operational Safety Guidelines Radio Overview Radio OverviewParts of the Radio Overview Radio Model Frequency Transmit Power Number Antenna Band Batteries and Chargers Battery Features and Charging OptionsAbout the Li-Ion Battery Batteries and Chargers Battery Recycling and Disposal Battery Latchbattery latch Slots Turn OFF the radio, if it is turned on Removing Alkaline Batteries Power Supply, Adaptors and Drop-in Tray Charger Battery Life Information Installing Spring Action Belt Clip Charging with the Drop-in Tray Single Unit Charger Charging the Battery Charging a Stand-alone Battery Adjustable bracket Standard High and Ultra High Capacity Charging a High Capacity Battery Standard Charger LED Indicator Drop-in Tray Charger LED Indicators Estimated Charging Time Status LED Status Comments Getting Started Talk Range Receiving a Call Getting Started Radio Status LED Indication Radio LED Indicators HANDS-FREE USE/VOX Getting Started With Compatible VOX Accessories Setting VOX Sensitivity Hands Free without Accessories iVOXBattery Save Microphone Gain End of Transmission Tone Roger Beep Tone Reset To Factory Defaults Learning To Read The Values The Radio Signals You Programming FeaturesProgramming Mode Features Programming Mode Reading your Radios Features Values Programming Features Programming Mode Reading Frequencies Values Entering Programming Mode Frequencies Programming Frequencies, Codes and Auto-Scan Saving SettingsReading Auto-Scan Values Programming Mode FAQ Just programmed the value I wanted Example of Programming a Code Example of Programming Auto Scan Other Programming Features Scan Nuisance Channel Delete Editing Scan List CPS Computer Programming Software Battery Type Setting Time-Out TimerBandwidth Select Call Tones Cloning with a Multi-Unit Charger MUC Programming Features Cloning Radios Press and release SB1 When ordering the MUC Operating Instructions What to do if cloning fails Cloning using the CPS Computer Programming Software Troubleshooting Troubleshooting Monitoring’ Section on page 24 for further information Light does not come on USE and Care USE and CareIf the radio is submerged in water Channel Radios PMR 446 Defaults Frequency and Code ChartsFrequency and Code Charts Ctcss Ctcss DPL Codes DPL Code Warranty Information WarrantyWhat is not Covered by the Warranty Motorola Limited Motorola Limited Warranty Accessories Chargers Page 6871663M06-A