Removing Alkaline Batteries | Motorola XTNI instruction

BATTERIES AND CHARGERS

Alkaline battery pack (optional accessory)

Installing Alkaline Battery Pack

Alkaline

Battery

Door

1.Turn OFF the radio, if it is turned on.

2.Remove Li-Ion battery

3.Assemble alkaline battery pack (optional accessory) in the same steps as installing the Li- Ion battery pack.

4.Remove battery door from alkaline battery pack.

5.Slide the 5 AA alkaline batteries into the frame, matching the markings inside the compartment.

Removing Alkaline Batteries

Alkaline

Battery

Door

1.Turn OFF the radio, if it is turned on.

2.Slide the battery latches, on both sides of the battery, downwards.

3.Pull the top of the battery away from the radio’s body, and lift the battery from the radio’s body.

English 14

Image 16

Motorola XTNI manual Removing Alkaline Batteries, Turn OFF the radio, if it is turned on

Contents

Page Page Contents Hands Free without Accessories iVOX30 Accessories Contents Computer Software Copyrights Computer Software Copyrights Safety Safety Batteries and Chargers Safety Information Batteries and Chargers Safety Information Operational Safety Guidelines Parts of the Radio Radio OverviewRadio Overview Radio Overview Model Frequency Transmit Power Number Antenna Band About the Li-Ion Battery Battery Features and Charging OptionsBatteries and Chargers Battery Recycling and Disposal Batteries and Chargers Battery Latchbattery latch Slots Removing Alkaline Batteries Turn OFF the radio, if it is turned on Power Supply, Adaptors and Drop-in Tray Charger Installing Spring Action Belt Clip Battery Life Information Charging the Battery Charging with the Drop-in Tray Single Unit Charger Charging a Stand-alone Battery Adjustable bracket Standard High and Ultra High Capacity Charging a High Capacity Battery Drop-in Tray Charger LED Indicators Standard Charger LED Indicator Estimated Charging Time Status LED Status Comments Getting Started Receiving a Call Talk Range Getting Started Radio LED Indicators Radio Status LED Indication With Compatible VOX Accessories HANDS-FREE USE/VOX Getting Started Hands Free without Accessories iVOX Setting VOX SensitivityBattery Save Microphone Gain Reset To Factory Defaults End of Transmission Tone Roger Beep Tone Programming Mode Programming FeaturesLearning To Read The Values The Radio Signals You Programming Mode Reading your Radios Features Values Features Programming Mode Programming Features Entering Programming Mode Reading Frequencies Values Frequencies Reading Auto-Scan Values Saving SettingsProgramming Frequencies, Codes and Auto-Scan Programming Mode FAQ Just programmed the value I wanted Example of Programming a Code Other Programming Features Scan Example of Programming Auto Scan Editing Scan List Nuisance Channel Delete CPS Computer Programming Software Time-Out Timer Battery Type SettingBandwidth Select Call Tones Programming Features Cloning Radios Cloning with a Multi-Unit Charger MUC When ordering the MUC Press and release SB1 Operating Instructions Cloning using the CPS Computer Programming Software What to do if cloning fails Troubleshooting Troubleshooting Monitoring’ Section on page 24 for further information Light does not come on If the radio is submerged in water USE and CareUSE and Care Frequency and Code Charts Frequency and Code ChartsChannel Radios PMR 446 Defaults Ctcss Ctcss DPL Codes DPL Code Warranty Warranty InformationWhat is not Covered by the Warranty Motorola Limited Motorola Limited Warranty Accessories Chargers Page 6871663M06-A