Motorola XTNI manual Just programmed the value I wanted

4.When I was programming I made a mistake and program the wrong value. How can I erase it or re-program it?

If you make a mistake while programming a value you have two choices:

a)The radio roll-over (and generates a 'wrap- around' sound) each time it reaches a maximum (9) or minimum (0) value. Keep increasing (short press SB1) or decreasing (short pressing SB2) until you get the desired value or,

b)Turn OFF the radio and start-over.

	5. I just programmed the value I wanted.
	How do I exit Programming Mode?
	• If you are in Programming Mode you can exit
PROGRAMMING FEATURES	by long pressing the PTT button twice.
	• If you are already in the ‘Idle’ Programming
	Mode, long press the PTT button once.
		38
English

6.I am done programming the features in this channel and want to program another channel.

Switch to the new channel you wish to program by using the Channel Selector Knob. The radio will go into to the 'Idle' Programming Mode. If you wish to save the changes, make sure you are in the ‘Idle’ Programming Mode before switching the channel as otherwise you will lose changes made.

PROGRAMMING VALUES EXAMPLE Example of Programming a Frequency

Assuming current frequency value is set up to channel 1, with the UHF default frequency ‘02’ (equivalent to 446.01875 Mhz), and you want to change it to Frequency Number = ‘13’ (which is mapped to 446.05625 Mhz), follow this sequence:

• Enter Programming Mode