•Short press the PTT button to enter Frequency Mode. Radio will signal current value ‘0’ (orange blink)
•Press the SB1 button once to increase first digit to ‘1’.
•Short press the PTT button once to move ahead and program the frequency’s second digit. Radio will signal current value which is ‘2’ (two red blinks).
•Press the SB1 button to increase the digit value to ‘3’.
•Long press the PTT button. LED indicator will show a green heartbeat to indicate 'Idle' state.
•Long press the PTT button to exit Programming Mode or turn radio OFF.
Example of Programming a Code
Assuming current code value is set to factory default ‘001’, and you want to change it to CTCSS/DPL Code = 103 follow the sequence below:
• Enter Programming Mode
• Short press the PTT button three times (Enter |
| ||
CTCSS/DPL Programming Selection Mode). |
| ||
Radio LED will blink orange to indicate that |
| ||
current value is ‘0’ • Press the SB1 button once |
| ||
(to change first digit to ‘1’) LED indicator will |
| ||
blink red. Short press the PTT button (to move |
| ||
forward and program second digit). Radio LED |
| ||
will blink orange to indicate current value is ‘0’. |
| ||
• Short press the PTT button and move ahead |
| ||
to program the third digit. LED indicator will |
| ||
blink red to indicate current value is ‘1’. |
|
| |
• Press the SB1 button to change the ‘third |
| ||
digit’ to ‘2’. Press the SB1 button to change |
| ||
again this ‘third digit’ to ‘3’. Radio will signal the |
| ||
chosen value. |
|
| |
• Long press the PTT button to save changes |
| ||
| |||
and return to 'Idle' Programming Mode. |
| PROGRAMMING FEATURES | |
• Once in 'Idle' Programming Mode, LED |
| ||
|
| ||
indicator will start blinking a green heartbeat. |
| ||
• Long press the PTT button to exit |
|
| |
Programming Mode. |
|
| |
39 |
|
|
|
|
|
| |
| English |
| |
|
|
| |
|
|
|
|
