What to do if cloning fails
The radio will emit an audible ‘bonk’ indicating that the cloning process has failed. In the event that cloning fails, try performing each of the following before trying to start the cloning process again:
1.Ensure that the batteries on both radios are fully charged.
2.Check the cloning cable connection on both SUCs.
3.Ensure that the battery is engaged properly on to the radio.
4.Ensure that there is no debris in the charging tray or on the radio contacts.
5.Ensure that the Source radio is in cloning mode.
6.Ensure that the Target radio is turned ON.
7.Ensure both radios are both from the same type. (same frequency band, same front panel (display/non display), same region and same transmission power).
Attention: This cloning cable is designed to operate only with compatible Motorola RLN6170 (Rapid) Single Unit Charger.
When ordering Cloning Cable please refer to P/N RLN6303. For details about accessories refer to Accessories section.
Cloning using the CPS (Computer
Programming Software)
When cloning using this method, you will need |
| |||
to have the CPS software, a |
| |||
Charger and the CPS Programming Cable. |
| |||
Information on how to clone using the CPS is |
| |||
available either in the CPS Help File |
|
| ||
Content and Index |
| |||
PROGRAMMING FEATURES | ||||
CPS Programming Cable Accessory Leaflet. | ||||
Note: (*) CPS Programming Cable is an |
| |||
|
| |||
accessory sold separately. For part number |
| |||
information refer to the Accessories Section. |
| |||
47 |
|
|
| |
|
|
| ||
| English |
| ||
|
|
| ||
|
|
|
| |
