BT 2300 manual Getting started, Talk/Standby time

Models: 2300

1 67
Download 67 pages 11.04 Kb
Page 8
Image 8

8 Getting started

The red Charging light stays on while the handset is on the base, even when the batteries are fully charged.

Talk/Standby time

Under ideal conditions, fully charged handset batteries should give up to 8 hours talktime or 80 hours standby on a single charge.

Battery low warning

The handset battery symbol is empty and you will hear a warning beep. Start recharging your handset right away.

When charging the battery, level bars are animated.

Replacing batteries

Use only rechargeable 750mAh or higher AAA NiMH batteries.

Battery performance

When batteries are fully charged the display shows 3 green bars.

To keep your batteries in the best conditions, leave the handset off the base for a few hours at a time (after the initial 24 hour charge).

Please note however, that new NiMH batteries do not reach full capacity until they have been in normal use for several days.

3.Install the 2 x AAA rechargeable batteries supplied. Then slide the battery compartment cover into place.

4.Charge the handset for at least 24 hours by placing it on the base. The red Charging light comes on. The handset is pre-registered to the base as Handset 1. The screen shows the standby display.

5.After 24 hours, plug the telephone line cord into the wall socket and your BT Studio 2300 base.

If you experience any problems, please call the Helpline on 0870 605 8047

Page 8
Image 8
BT 2300 manual Getting started, Talk/Standby time