Buffalo Technology WHR-G54S user manual Configuring a WDS Bridge

Configuring a WDS Bridge

On the left-side menu, click on Wireless Config, and then Repeater.

Repeater-Bridge (WDS) must be set to Enable. If it is not, change it to Enable in the drop down menu and click Apply. After the AirStation reboots, the screen will refresh. Click Edit Registered WDS Partners.

Under Add New WDS Partner Access Point, enter the wireless MAC address of the second AirStation, the one that you want to form a bridge with. You can get this from the bottom of the second AirStation (see above). Enter it with each pair of digits separated by a colon, e.g. 000D0B10F778 would be entered “00:0D:0B:10:F7:78”. Press New Partner when done. The AirStation will reboot, and when the screen refreshes, the second AirStation’s MAC address will be listed under Bridgeable Access Points.

71