SERVICE (cont.)
BREW SWITCH (Start) - Model CEZ-APS/TS/TSR
|
|
|
|
| . |
|
|
|
| - | U |
MODEL |
|
| A.C. | THE |
|
| VOLTS MOREOF |
| BE PENDING | ||
|
| PHASEOR |
| ||
| UNDER | ONE |
| MAY |
|
COVERED |
|
| PATENTS |
| |
|
| OTHER |
|
| |
| OR MORE |
|
|
| |
ONE |
|
|
|
| |
|
|
|
|
| SOURCEOR |
|
| ! | WARNING | ||
|
|
| POWERPANEL | ||
|
|
|
| ||
|
|
|
| ANY | |
|
|
| FROMOF | COMPONENT! | |
|
| REMOVALOF ANY |
| ||
DISCONNECT |
|
| |||
BEFORE |
|
|
|
| |
REPLACEMENT |
| P1917 | |||
|
|
|
|
| |
| FIG. 7 BREW SWITCH |
Location:
The BREW switch is located in the center front of the hood.
Test Procedure:
1.Disconnect the brewer from the power source.
2.Disconnect the white/yellow wire from the top switch terminal and the white/orange from the bottom switch terminal.
3.Check for continuity across the two terminals on the switch when it is held in the lower position. Continuity must not be present across these ter- minals when the switch is released.
If continuity is present as described, reconnect the white/yellow wire to the top terminal and the white/ orange to the bottom terminal.
If continuity is not present as described, replace the switch.
Removal and Replacement:
1.Remove the white/yellow wire and white/orange from the BREW switch.
2.Compress the clips inside the hood and gently push the switch through the opening.
3.Push new switch into the opening and spread the clips to hold the BREW switch in the hood.
4.Refer to FIG. 8 when reconnecting the wires.
WHI/YEL from
Control Board
WHI/ORA from
Control Board
P1851
FIG. 8 BREW SWITCH WIRING
Page 26 | 29253 091603 |
|