OPERATING CONTROLS
Model CEZ-APS/TS/TSR
P1910 |
ON/OFF SWITCH
Placing the "ON/OFF" switch in the "ON" upper position enables the brew circuit, and energizes the tank refill circuit. Placing the switch in the "OFF" lower position stops tank refilling and brewing. Stop- ping a brew cycle after it has been started will not stop the flow of water into the server until the funnel is empty.
NOTE Ð Hot water will be available at the faucet in a limited amount when the switch is in the "OFF" position because the tank will not refill.
BREW SWITCH
Momentarily pressing and releasing the switch starts a brew cycle when the "ON/OFF" switch is in the "ON" upper position.
NOTE Ð The "ON/OFF" switch must be in the "ON" upper position to initiate and complete a brew cycle.
READY INDICATOR
This indicator glows when the preselected brew water temperature has been achieved.
Model CDBC-APS/TC/TS/TSR
P1911 |
ON/OFF SWITCH
Pressing the "ON/OFF" switch (indicator glowing) enables the brew circuit and energizes the tank refill circuit. Pressing the switch again (indicator not glowing) stops tank refilling and brewing. Stopping a brew cycle after it has been started will not stop the flow of water into the server until the funnel is empty.
NOTE Ð Hot water will be available at the faucet in a limited amount when the "ON/OFF" indicator is not glowing because the tank will not refill.
BREW SWITCH
Momentarily pressing and releasing the switch starts a brew cycle when the "ON/OFF" indicator is glowing. NOTE Ð The "ON/OFF" indicator must be glowing to initiate and complete a brew cycle.
READY INDICATOR
This indicator glows when the preset temperature has been achieved. The word "NOT" above "READY" will glow in all other instances.
TEMPERATURE INDICATORS (Feature disabled from the factory Ð refer to page 8.)
The indicator glows to communicate the brew water temperature. Two indicators will glow when the temperature is between them.
Page 5 | 29253 111103 |
|