![](/images/new-backgrounds/1071523/7152357x1.webp)
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
TEA RECIPES: SET PULSE BREW
This function allows the operator to program the brewer to “pulse” the sprayhead flow on and off during a brew cycle (start and stop the flow of water out of the spray- head). This feature allows the ability to
INITIAL SPRAY | ON- | ON- |
| ON- |
TIME | TIME |
| TIME ALTERNATES UNTIL | |
|
| |||
|
|
|
| BREW CYCLE IS |
OFF- | OFF- |
| OFF- | COMPLETED |
|
| |||
TIME | TIME |
| TIME |
|
INITIAL SPRAY |
|
|
|
|
REMAINING ON |
|
|
| |
|
|
| P2293 | |
|
|
|
|
a)1st ON TIME – This time is the duration from when the brew button is pressed to when the desired water level in the funnel is reached. (Soaking the tea leaves)
b)
c)LAST
These three times can be set two different ways. The first is by setting the total brew time and using a calcu- lated pulse routine. This is done by utilizing the EASY PULSE BREW screen and following the setup for that function.
Setting Pulse Brew – EASY Pulse Brew
Range: Minimum: will adjust to the minimum time required to brew that batch using the set brew vol- umes and flow rate for the sprayhead. Maximum
–will adjust depending on settings. Will always be minimum time + 3 minutes. The brewer will automati- cally calculate what the 1ST ON TIME, OFF TIMES, and LAST ON TIME will be using the initial on time, plus a 7 pulse routine.
The other option allows the actual times to be entered for each of the settings. This is done by utilizing the MANUAL PULSE BREW screen and following the sub- sequent steps under that function.
Setting Pulse Brew – MANUAL Pulse Brew Range: 1ST ON TIME – off to 1 minute OFF TIME – off to 20 seconds
LAST ON TIME –
Page 29 | 36748 070706 |
|