SERVICE
This section provides procedures for testing and replacing various major components used in this brewer should service become necessary. Refer to Troubleshooting for assistance in determining the cause of any problem.
WARNING - Inspection, testing, and repair of electri- cal equipment should be performed only by qualified service personnel. The brewer should be unplugged when servicing, except when electrical tests are re- quired and the test procedure specifically states to plug in the brewer.
COMPONENT ACCESS
WARNING - Disconnect the brewer from the power source before the removal of any panel or the replace- ment of any component.
All components are accessible by the removal of the top cover or warmer housing, front access panel and warmer plate(s).
The top cover is attached with one
The front access panel is attached with four
Each warmer assembly is attached with three #4- 40 screws.
Contents |
|
Control Board - CDBC & SINGLE CD | 23 |
Switch Panel - CDBC & SINGLE CD | 24 |
Dispense Valve | 25 |
Limit Thermostat | 26 |
Tank Heater | 27 |
Refill Valve | 29 |
Warmer Elements | 30 |
Wiring Diagrams | 31 |
P2675 |
FIG. 1 COMPONENT ACCESS |
Page 22 | 35582 041503 |
|
