SERVICE (cont.)
SWITCH PANEL
P1848 |
FIG. 3 SWITCH PANEL |
Location:
The Switch Panel is located in the front of the hood.
Test Procedures:
The test procedures for the switch panel and the control board will vary depending upon the problems experienced by the brewer. Refer to the Troubleshoot- ing guide beginning on page 11. The troubleshooting guide is divided into three sections, Refill Circuit, Heating Circuit, and Brewing Circuit.
Removal and Replacement:
1.Disconnect the
2.Remove the four #6 screws, nylon washers and the two
3.Gently pry the switch panel from the end cap
assembly.
4Remove any adhesive that remains on the end cap.
5.Remove the adhesive backing from the new switch panel. Insert the ribbon connector through the slot in the end cap and apply the switch panel to the end cap.
6.Install the control board to the back side of the end cap using the four #6 screws, nylon washers and the two
NOTE: The four nylon washers must be installed under the heads of the four #6 screws to prevent a possible shorting of the control board circuits.
7.Reconnect the
Page 24 | 35582 041503 |
|