SERVICE (cont.)
SELECTOR SWITCH (HALF BATCH OPTION)
! |
|
BEDISCO |
|
FORENNECTWARNING |
|
FROMP |
|
REPLACEMENTREMOVAL OFOWER |
|
OF ANY |
|
ANY PASOURCENEL |
|
COMPONENT!OR |
|
WAR | NING |
| |
| P2130.25 |
FIG. 16 SELECTOR SWITCH (HALF BATCH) | |
Location: |
|
The selector switch is located to the right of the front access panel above the start switch.
Test Procedures:
1.Disconnect the brewer from the power source.
2.Disconnect the wires from the switch terminals.
3.Check for continuity across the switch terminals with the switch in the "CLOSED" (lower - half) position. Continuity must not be present when the switch is in the "OPEN" (upper - full) position.
If continuity is present as described, the switch is operating properly.
If continuity is not present as described, replace the switch.
Removal and Replacement:
1.Remove the wires from the switch terminals.
2.Compress the clips on the back side of the switch and gently push them through the opening.
3.Push the new switch into the opening and spread the clips to hold switch.
4.Refer to Fig. 17 and reconnect the wires.
GRY to Brew Timer
PNK to Brew Timer
P2118.60
FIG.17 SELECTOR SWITCH TERMINALS
Page 22 | 10067.3 070102 |
|
