SERVICE
This section provides procedures for testing and replacing various major components used in this brewer should service become necessary. Refer to Troubleshooting for assistance in determining the cause of any problem.
WARNING - Inspection, testing, and repair of electri- cal equipment should be performed only by qualified service personnel. The brewer should be unplugged when servicing, except when electrical tests are re- quired and the test procedure specifically states to plug in the brewer.
COMPONENT ACCESS
WARNING - Disconnect the brewer from the power source before the removal of any panel or the replace- ment of any component.
The control thermostat, limit thermostat, pump, solenoid valve, liquid level probe, swing spout switch and tank heater are accessible by removal of the swing spout, side cupola covers and the cupola.
Disconnect the swing spout nut from the swing spout base fitting. Remove swing spout.
Remove the four
Slip cupola off of the component bracket.
The on/off switch, selector switch, start switch, timer, contactor and liquid level control board are accessible by removal of the front access panel.
Remove the four
The fuse and fuse holder are accessible by removal of the rear utility cover.
Remove the six
Contents |
|
Contactor | 14 |
Control Thermostat | 15 |
Fuse and Fuse Holder | 16 |
Limit Thermostat | 17 |
Liquid Level Board and Level Probe | 18 |
ON/OFF Switch | 20 |
Pump | 21 |
Selector Switch (Half Batch) | 22 |
Solenoid | 23 |
Start Switch (Brew) | 24 |
Swing Arm Switch | 25 |
Tank Heater | 26 |
Thermal Fuse | 27 |
Timer | 28 |
Digital Timer | 29 |
Wiring Diagram | 31 |
! | WARN |
|
|
BDISCONN | ING |
| |
REEFOPLACRE RECEMOTFROM |
| ||
EMENTVAOFLAONYPOWFANYERPASOUR |
| ||
|
| COMPNEL OCE |
|
|
| ONENTR! |
|
|
| WAR | NING |
|
|
| |
|
|
| P2130.25 |
FIG. 1 COMPONENT ACCESS | |||
Page 13 | 10067.3 070102 |
|
