Preparing and Installing the 9A426-02 Module
BOOT PROM
The 9A426-02 Module is shipped with a BOOT PROM. The BOOT PROM is located on the underside of the module’s daughterboard as shown in Figure 2-10.
To upgrade the BOOT PROM, install the BOOT PROM Upgrade Kit. Installation instructions are included in the upgrade kit.
FLASH SIMM
The 9A426-02 Module is shipped with a 4Mb FLASH SIMM. The FLASH SIMM’s socket is located on the underside of the module’s daughterboard as shown in Figure 2-10.
To upgrade the FLASH SIMM, refer to the installation instructions included in the FLASH SIMM Upgrade Kit.
DRAM SIMM
The 9A426-02 Module is shipped with 16 Mb of DRAM (on the module’s motherboard). However if additional DRAM is desired, you can install a DRAM SIMM in the socket on the underside of the module’s daughterboard as shown in Figure 2-10.
To install a DRAM SIMM, refer to the installation instructions included in the DRAM SIMM Upgrade Kit.
Installing the Module into the SmartSwitch 9000 Chassis
To install the 9A426-02 Module into the SmartSwitch 9000 Chassis, follow the steps below:
To insure proper data transmission from the 9A426-02 Module to the INB on the SmartSwitch 9000 backplane, two INB Terminator Modules must be installed on the rear of the SmartSwitch 9000 chassis. Refer to the INB Terminator Module Installation Guide for information and installation procedure.
1.Remove the blank panel covering the slot in which the module is being installed. If you are only installing one module, make sure the chassis’ other module slots are covered. This action ensures proper airflow and cooling.
