Cabletron Systems ELH100 manual Optional Modules, Module Components

Optional Modules

Figure 1-2 shows the optional modules available for the Cabletron ELH100-12/24TX. Table 1-2 defines the optional module components.

Figure 1-2. Optional Modules

Table 1-2. Optional Module Components

Module	Components
10Base-T/100Base-TX	Ports: Copper ports using RJ-45 connectors. Use either
	the MDI-X or MDI connector when attaching a device
	to this module. (See 10Base-T/100Base-TX Ports on
	page 24 for a detailed description of these ports.)
	Mode switch: If the attached device must operate at
	100 Mbps, full duplex, then set this switch to 100Full;
	otherwise, set it to Auto.
	Port LEDs: See Table 1-3 for details.
100Base-FX	Ports: Fiber ports using SC connectors for uplink. (See
	100Base-FX Fiber Ports on page 25 for a detailed
	description of these ports.)
	Mode switch: If the attached device must operate at full
	duplex, set this switch to Full; otherwise, set it to Half.
	Port LEDs: See Table 1-3 for details.
Agent	Console port: Male DB-9 connector configured as a
	null modem connection for serial out-of-band
	management using the console menus, or for in-band
	management when used with SLIP protocol.
	Active LED: On when the Agent Module is active; off
	when the module is in standby mode, and flashing if
	the module failed the power-on self-test.
	Only two agent modules are allowed in a stack: one
	active and one in standby mode.

9033060 Product Overview 5