Configuring Port Operation
You can configure 10/100 ports on the base unit for operational parameters such as enabled/disabled, and port speed or
To configure port operation, do the following:
1.Select Port Configuration from the Main Menu.
2.Select Administrative Status Control from the Port Configuration menu.
3.Select Port Group
4.Highlight any port, and select “Enabled” or “Disabled” in the Admin State field to toggle between enabling and disabling the port(s).
5.Select “Force 10,” “Force 100” or “Auto” under the Mode field to set the port speed to 10 Mbps, 100 Mbps or
The console interface can only enable/disable the ports on switch/media modules. To configure the speed/mode, use the 100Full/Auto toggle switch on the
Spanning Tree
The Switch/Media modules do not support Spanning Tree, which is intended to prevent network loops from forming. There is no loop detection.
The user is cautioned to understand and avoid configurations that can create a loop. However, if the
Setting a Default Gateway
The Default Gateway parameter defines the IP address of a router or other network device which is on the same subnet as the hub. The gateway receives IP packets that are to be sent to another subnet.
To set a default gateway, do the following:
1.Select System Configuration Menu from the Main Menu.
3.Enter the gateway IP address under New Setting. Select <APPLY>.
58 Configuring & Monitoring the Hub |