Using the TSX-1620 Hub View
2-4 Using the Hub View
Uptime
The time that the device has been running without interruption. The counter
resets to 0 days 00:00:00 (days:HH:MM:SS) when one of the following occurs:
• Power to the device is cycled.
• The device is reset manually.
Device Name
This field displays the device’s MIB II ifName value. You can set this value using
the SNMP MIB2 System Group window, available from the Interface menu.
Consult your SPMA Tools Guide for detailed information about the System
Group window and its use.
Device Location
This field displays the device’s MIB II ifLocation value. You can set this value
using the SNMP MIB2 System Group window, available from the Interface menu.
Consult your SPMA Tools Guide for detailed information about the System
Group window and its use.
IP Address
The device’s Internet Protocol address; this field will display the IP address you
have used to create the TSX-1620 icon (if you are running the Hub View from a
management platform) or the IP address you used to launch the Hub View
program (if you are running in stand-alone mode). You cannot change the TSX-
1620’s IP address from SPMA.
Clicking the Device button displays the Device menu, Figure 2-2, which lets you
open the Polling Intervals window.
Figure 2-2. TSX-1620 Hub View Device Menu
See Setting the Polling Intervals on page 2-15 for details about the Polling
Intervals window.
Note that the Device menu does not provide access to every application which is
available to the TSX-1620; some information is only available from the Module,
Interface, Bridge, and/or Bridge Port menus, and several applications can only be
accessed either from the icon menu (if you are running under a network
management platform) or from the command line (if you are running in stand-
alone mode). See Chapter 1, Introduction to SPMA for the TSX-1620, for a
complete list of applications available to the TSX-1620 and how to access each
one.