Remote Control Operation Figure | Cal Flame 3000 guide

Owner’s Manual

Cal Flame Entertainment System

Remote Control Operation (Figure 44)

1.TV Controls:

a.TV Power

Press this button to turn on the set. Press the button again to turn the set off.

2.Direct Access (0-9, 1--) Number Buttons

Use these buttons to select a channel. The channel number chosen will be displayed on the screen for about four seconds. To select channels 0-99, press two numbers. For example, to select channel 8, press 0,8. To select above 100, press the 1-button, then the number buttons for the last two digits of the channel. For example, to select channel 115, press 1--, 1,5.

3.CHANNEL Up and Down

Use these buttons to select pre-programmed channels of two select channels up or down.

4.VOLUME Up and Down

Use these buttons to raise or lower the volume level of the Wired Headphones or External Speakers if installed. They are also used to make adjustments in the picture mode.

NOTE: These buttons will not affect the volume of wireless headphones or a wired RF modulator. When using these devices, the volume must be adjusted with the headphone volume control or with your radios volume control.

5.MENU Button

Press the MENU button. The MENU display appears. Use the Channel Up and Down buttons to select the desired function, then press ENTER button to end the choice.

6.TV/VIDEO Button

Press this button to access the AUDIO/VIDEO input jacks, on the front and rear of the TV. As the button is pressed, the on-screen display will cycle as follows:

TV AV1 AV2 AUX

7.MUTE Button

Press this button to turn the TV sound off. Press again to restore sound to the previously set level. MUTE may also be released by pressing the VOLUME +/-.

8When tuned to a channel press this button to store or erase the channel from memory. The stored channel numbers are displayed in GREEN on the screen and the no stored channel numbers are in RED.

9.AUTO PROGRAM Button

Select the regular channel broadcast TV or CABLE TV for AUTO PROGRAM. All the channel numbers for TV or CABLE TV will be scanned. The broadcasting signals will be detected and automatically stored.

10.ENTER Button

Use this button to end the choice on the menu.

11.PICTURE SELECT Button

Each time this button is pressed the on-screen picture adjustment display cycles through “adjustment screens” as follows:

BRIGHTNESS CONTRASTCOLOR SHARPNESS TINT