Cal Flame G3000 owner manual Assembly and Installation

Assembly and Installation

Figure 10 Figure 11

4.Insert the bolts through the pre-drilled holes from the inside of the barbecue island (total of four bolts on each side) (Figure 12).

5.Insert the upper bolts as shown (Figure 13). Tighten the bolts all the way using a 9/16" wrench.

Figure 12 Figure 13

6.Prepare and fill the gap or seam line with speed set (Figure 14).

7.Using your fingertips, push and flatten out the speed set into the seam line (Figure 15).

Figure 14 Figure 15

NOTE: Allow the speed set to dry before proceeding with the next step.

8. Using a small brush or hopper gun, apply stucco to the seam line (Figures 16 and 17).

Page 12 Barbecue Owner’s Manual

www.calspas.com 12/17/04