Assembly and Installation
G3000 Island / Sports Bar Canopy
While the G3000 Island / Sports Bar Canopy is intended for outdoor use, some precautions must be taken when using and caring for your new Cal Flame™ equipment. When the equipment is not being used, or especially in times of inclement weather, it is the owners responsibility to remove and store the electronic equipment that is listed in this manual. When storing the equip- ment, it is strongly advised that the equipment be stored in a dry and
Any damage incurred from moisture is not covered by the warranty. These preventative care measures must become a part of the owner’s maintenance routine. In addition, all efforts should be taken by the owner to keep excessive dirt and foreign debris from settling into the island enclosure. If these requirements are neglected, all warranties on the audio and video components will be void. With a little care and maintenance, you can look forward to many
Canopy Wiring
Prior to assembling the bar and the canopy, you must wire the unit. The wiring plan has been designed with simplicity in mind. Electrical service for this unit requires a 120V/20 amp circuit breaker for correct operation. If there are any questions dealing with the wire code, please refer to Figure 23. Run all wiring before the final assembly of the barbecue and before the initial assembly of the canopy.
Figure 23. Canopy wiring diagram
The following sections show how each wiring connection is to be made. These connections will be identi- cal for the top and bottom of the canopy support post. Make sure that after the connections are made, the
Barbecue Owner’s Manual | Page 19 |
12/17/04 | www.calspas.com |
