Cal Spas LTR20051000 Operating Your Spa, 1500 Electronic Control Operation, Standard Heating Mode, Temperature Adjustment, Jet / Light Controls (One Pump Systems)

Operating Your Spa

Operating Your Spa

1500 Electronic Control Operation

Figure 4. 1500 Electronic control panel

Temperature Adjustment

Range 80°F to 104°F

The 1500 electronic control panel (Figure 4) displays the actual water temperature in Fahrenheit. To set the water temperature:

•Press the TEMPERATURE button. The temperature setting will flash.

•While the display is flashing, each time you press the TEMPERATURE button the set temperature will increase one degree.

•Allow the display to revert back to the actual water temperature.

•Press the TEMPERATURE button again.

•While the display is flashing, each time you press the TEMPERATURE button the the set temperature will decrease by one degree.

Standard Heating Mode

Your new spa is equipped with a heating feature that gives you complete control of the heating system. When the spa is powered up, the heating system will automatically activate. Whenever the water temperature drops more than one degree below the set temperature, the heating system will automatically activate and heat the spa water to the set temperature.

Jet / Light Controls (One Pump Systems)

Press the JETS button:

•Once to activate the spa light

•Once to activate the pump at low speed

•Twice to activate the spa light and run the pump at high speed

2005 Spa Owner's Manual Page 13

8/1/2005