Operating Your Spa

NOTE: Neck jets will be reversed when adjusting pressure.

Diverter Knobs

Diverter knobs are the larger knobs located around the top of your spa (Figure 12). They allow you to divert water through jets from one side of the spa to the other, or in most cases from floor jets to wall jets. This is accomplished by simply rotating the diverter knob to the left (counterclockwise), decreasing the amount of water flow through a section of jets. To increase the amount of water flow through the other section of jets, simply rotate the handle to the right (clockwise).

Figure 12. Diverter knob

Cal Spas™ Flow Diverter

The Cal Spas™ Flow Diverter system (Figure 13) uses one or more motorized valve(s) to vary the jet action between certain zones in the spa. These valve(s) are preset to stop at seven different positions. Those positions are represented by the LED lights on the Flow Diverter control panel.

As the valve(s) move, the LEDs will alternate between the current position and the desired position until the desired position is reached.

Upon power-up, all the LEDs will illuminate one at a time as the valve(s) move for approximately 17 seconds. Immediately following this start-up process, the valve(s) will move to the center position, at which time the center LED will light.

Figure 13. Cal Spas™ Flow Diverter

2005 Spa Owner's Manual

Page 37

8/1/2005