Appendix

9800 Configuration Settings

WARNING! SHOCK HAZARD!

There are no user serviceable parts. DO NOT attempt service of this control system. Contact your dealer or service center for service.

DIP Switches and Jumpers

Note: Switchbank B is totally disabled.

 

 

A1

Test mode OFF

A7

N/A

 

 

A2

Add 1 pump with heat

A8

N/A

 

 

A3

Add 2 pumps with heat

A9

N/A

 

 

A4

N/A

A10

No edit

 

 

A5

N/A

A11

N/A

 

 

A6

N/A

A12

Memory ON

 

 

A1

Test mode OFF

A7

N/A

 

 

A2

Add 1 pump with heat

A8

N/A

 

 

A3

Add 2 pumps with heat

A9

N/A

 

 

A4

Add 3 pumps with heat

A10

No edit

 

 

A5

N/A

A11

N/A

 

 

A6

N/A

A12

Memory ON

 

 

A1

Test mode OFF

A7

N/A

 

 

A2

Add 1 pump with heat

A8

N/A

 

 

A3

Add 2 pumps with heat

A9

N/A

 

 

A4

N/A

A10

No edit

 

 

A5

N/A

A11

N/A

 

 

A6

N/A

A12

Memory ON

DIP Switch Key

 

 

 

 

A1

Test mode (normally off)

 

 

 

A2

In ON mode, add one high-speed pump (or blower) with heater

 

 

A3

In ON mode, add two high-speed pumps (or one high speed pump and blower) with heater

A4

In ON mode, add four high-speed pumps (or three high speed pumps and blower) with heater

A5—A9

N/A

 

 

 

A10

When switched on when spa is on, system will enter the Edit Menu for configuration settings. Do

 

not start the spa with A10 turned on or a CFE error will occur. (CFE errors are illegal configurations

 

such as a pump and blower set to run on the same output. The configuration must be corrected

 

before the spa will operate.

 

 

 

A11

N/A

 

 

 

A12

Persistent memory reset (used when spaq is powering up)

 

 

Note: A2, A3, and A4 work in combination. Example: A2 and A3 in the ON position and A4 in the OFF position will allow 3 high speed pumps (or two high speed pumps and the blower) to run with the heater.

2005 Spa Owner's Manual

Page 69

8/1/2005