Operating Instructions and Parts Manual

General Safety (continued)

Hazardous vapors: Paints, solvents, insecticides, and other materials may be harmful if inhaled, causing severe nausea, fainting, or poisoning.

 

SPRAYING MATERIAL

NEEDLE/NOZZLE

 

 

 

 

Acrylics

All purpose or Thin

 

Stains

Thin

 

Sealers

Thin

 

Lacquers

Thin

 

Latex Paint

All purpose

 

Oil Base Paint

All purpose or Thick

 

 

 

Use a respirator or mask whenever there is a chance that vapors may be inhaled. Read all instructions with the mask to ensure

Chart 1 - Material Needle/Nozzle Combination

that the mask will provide the necessary protection against the inhalation of harmful vapors.

NEVER point the spray gun at any part of the body, or at anyone else.

!CAUTION Tipping the gun causes the gun to clog. Dried spray material also clogs the pressure delivery tube and fittings. The spray gun does not function when clogging occurs.

When not in use, be sure to disconnect the hose and place the gun on a solid, level surface to avoid tipping.

Components

(1)Gun - fully assembled, with all purpose needle/nozzle installed

Setup

NEEDLE AND NOZZLE ASSEMBLY

1.Use Chart 1 to determine the proper size nozzle and needle for the material to be applied. The all purpose needle and nozzle are installed at the factory.

(1) Groove Ring

(1) Groove Ring

Figure 2 - Thin Material Needle And Nozzle Kit

3.The all purpose material needle and nozzle have three groove rings as shown in Figure 3 below.

(3) Groove Rings

(3) Groove Rings

Figure 3 - All Purpose Material Needle And Nozzle Kit

4.The thick material needle and nozzle have 2 groove rings as shown in Figure 4 below.

(2) Groove Rings

(2) Groove Rings

Figure 4 - Thick Material Needle Kit

Note: The all-purpose material needle kit is included with the unit. The thick and thin material needle kits are not included, however these kits can be purchased from the retail outlet that sold the unit or call 1-800-626-4401.

5.Remove the retaining ring, air cap, nozzle, material control knob, spring, and needle assembly (Fig. 5).

IMPORTANT: The needle and nozzle are a matched assembly. It is very important that both the needle and nozzle are correctly selected and installed. The needle/nozzle kits are identified by groove rings machined into both the needle, and the nozzle. Make sure that the number of rings in the nozzle and the needle match. Failure to match these two components properly results in poor finish quality.

2.The thin material needle and nozzle have a single groove ring as shown in Figure 2 below.

Material Flow

Control Knob

Air Flow

RetainingRing

Ring

Nozzle

Spring

Needle

Assembly

Air Cap

Wrench

(located inside

storage

compartment)

Figure 5 - Needle/Nozzle Installation

www.chpower.com

2

Page 2
Image 2
Campbell Hausfeld HV2002, IN206701AV, HVLP Components, Setup, Spraying Material NEEDLE/NOZZLE, Needle and Nozzle Assembly