Section 4. TLX106 Sensor Arm Installation

4.1Components

(1)TLX106 Sensor Arm

(1)Met One 034A Wind Sensor

(1)034A Mounting Shaft

(1)Radiation Shield

4.2 Installation

Install the TLX106 Sensor Arm after the Enclosure is mounted low on the Tower. You may need to temporarily remove communications option. Mount the sensor arm as shown in Figure 4.2-1 without the wind sensor attached.

ET Sensor

 

Arm

ET Enclosure

Screws

(4)

FIGURE 4.2-1. TLX106 Sensor Arm Mounting

1)Remove the cover from the Enclosure.

2)Place the sensor arm on top of the enclosure, lining up the four threaded holes on the under side of the arm with the four holes in the top of the enclosure. Attach the arm to the enclosure by inserting and tightening four Phillips head screws. Adjust the position of the Enclosure so that the sensor arm is oriented along a due east to due west axis.

4-1