Section 4. TLX106 Sensor Arm Installation

4.5 RH and Temperature Radiation Shield

Mount the radiation shield to the sensor arm as shown in Figure 4.4-1. Remove yellow cap. Place the RH and temperature assembly inside the shield shaft. Attach the shield to the sensor arm with the two screws.

4.6 Pyranometer

Level the pyranometer as indicated in Figure 4.6-1. Adjust the three leveling screws until the bubble level indicates plumb. Remove the red cap from the pyranometer.

Leveling

Screws

FIGURE 4.6-1. Pyranometer Leveling

4.7 Sensor Verification and Clock Set

Check the measurements of all sensors after the datalogger is programmed.

Display measurements using the *6 Mode with the CR10KD.

4-3