114
E
Using a Memory Card
(ELURA20 MC only)
4. Select the desired setting.
• Your currently recording image is combined with the pre-recorded still
image.
5. Select MIX LEVEL.
6. Adjust the mix level.
• Turning the SELECT dial upwards adjusts to the right and turning
downwards adjusts to the left.
7. Close the menu.
• CARD MIX flashes in the display.
8. Press the card MIX button.
• CARD MIX stops flashing.
• Your currently recording image is combined with the pre-recorded still
image.
• Each time you press the card MIX button, your selection is activated
(display lights continuously) or deactivated (display flashes).
1. Press the start/stop button to start and stop recording.
• The combined images are recorded onto the cassette.
1. Press the PHOTO button halfway down and hold it.
•Fflashes white in the display as the camera adjusts the focus and it is
displayed continuously as a green mark when the camera is ready to take the
image.
2. Press the PHOTO button fully down to record the image to the
cassette.
•Fdisappears from the display.
• The combined images are recorded onto the cassette for approximately 6
seconds (8 seconds in the SPor LP recording mode).
• You cannot use Card Mix in the Low Light recording program (in MOVIE and
P.SCAN modes).
• If you change the position of the POWER dial or move the program selector
from Qto [Easy Recording mode, select your still image for Card Mix
again.
• When setting Card Mix, you must carry out steps 1 to 5.
For a still image
For a moving image
On/Off