Canon 7585 manual Serial Control Interface, Operation, Example

Appendix

Serial Control Interface

This projector provides a function to control and monitor the projector's operations by using the RS-232C serial port.

Operation

1Connect a RS-232C serial cross cable to CONTROL PORT on the projector and serial port on the PC. (See p.20)

2Launch a communication software provided with PC and setup the communication condition as follows:

Baud rate	: 9600 / 19200 bps
Parity check	: none
Stop bit	: 1
Flow control	: none
Data bit	: 8

Note:

•The default of the baud rate is set to 19200 bps. If an error occurs in the communication, change the serial port and the communication speed (baud rate).

3Type the command for controlling the projector and then enter the "Enter" key.

Example

When you want to change the input to INPUT 2, Type 'C' '0' '6' 'Enter'.

Note:

•Enter with ASCII 64-byte capital characters and one- byte characters.

78