Part Names and Functions
Remote Control Battery Installation
Open the battery
1compartment lid.
Press the lid downward and slide it.
2 | Install new batteries into | 3 | Replace the |
the compartment. | compartment lid. |
Two AAA size batteries
For correct polarity (+ and
To insure safe operation, please observe the following precautions :
LUse two (2) AAA or LR03 type alkaline batteries.
LAlways replace batteries in sets.
LDo not use a new battery with a used battery.
LAvoid contact with water or liquid.
LDo not expose the remote control unit to moisture or heat.
LDo not drop the remote control unit.
LIf the battery has leaked on the remote control unit, carefully wipe the case clean and install new batteries.
LRisk of an explosion if battery is replaced by an incorrect type.
LDispose of used batteries according to the instructions.
Remote Control Receivers and Operating Range
Point the remote control unit toward the projector (to Infrared Remote Receivers) when pressing the buttons. Maximum operating range for the remote control unit is about 16.4’ (5 m) and 60 degrees in front and rear of the projector.
Infrared Remote Receivers are provided both in front and back of the projector. You can conveniently use both of the receivers (pp. 10, 51).
16.4’ (5 m)
16.4’ (5 m)
Wired Remote Control Transmitter
The remote control unit can be used as a wired remote control unit. Wired remote control unit helps you use the remote control unit outside of the operating range (16.4’/ 5 m). Connect the remote control unit and the projector with the remote control cable (sold separately). Connected with the remote control cable, the remote control unit does not emit wireless signal.
15
