Canon 7585 manual Setting, Note, Lamp mode, Filter control, Fan control, Remote control

Setting

Lamp mode

This function allows you to change the brightness of the screen.

Auto mode . . . . . . Brightness according to the input signal.

Normal mode . . . . Normal brightness.

Eco 1 mode . . . . . Lower brightness and Fan control set to Normal. Lower brightness reduces the lamp power consumption and extends the lamp life.

Eco 2 mode . . . . . Lower brightness and Fan control set to Max. Lower brightness reduces the lamp power consumption and extends the lamp life. It is recommended to use Eco 2 mode when using the projector continuously over a long period of time. The fan noise becomes louder in Ecot 2 mode than in Eco 1 mode. Select the suitalbe mode for the used environment.

Filter control

You can replace the filter with this function. Press the OK button at Filter control to display a confirmation box. To replace, press the OK button at “YES” and the electrically operated filter starts to scroll.

You can also replace the filter by using the remote control unit (p. 29).

Fan control

Choose the running speed of cooling fans from the following options.

Normal....... Operate in this mode under normal conditions.

Max ........... Use this mode when you want to increase the

cooling effect when operating the projector in high ambient temperature environment. Fan noise is lounder than “Normal”.

Remote control

The eight different remote control codes (Code 1–Code 8) are assigned to the projector; the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8).

The same code should set on both the projector and the remote control unit. For example, operating the projector in “Code 7”, the remote control code also must be switched to “Code 7”.

To change the code for the projector

Select a remote control code in this Setting Menu.

To change the code for the remote control unit:

Press and hold the MENU button and a number button (1–8) on the remote control unit for more than 5 seconds to switch between the codes (p. 16).

RC sensor

Select a location of the infrared remote receiver of the remote control unit. See “Remote Control Receivers and Operating Range” on page 15 for details.

Both	Activate both the front and back receiver.
Front	Activate only the front receiver.
Back	Activate only the back receiver.

Note:

•Filter replacement icon and “Please wait...” message appear on the screen when the filter is being scrolled.

•When the filter is replaced, the total accumulated time of the filter use is automatically set to 0.

Remote control

When pressing the OK button at Remote control unit, the Remote control code menu appears.

51