Using Wireless FlashN

5Select [Wireless func.].

For [Wireless func.], select [0], then press <0>.

XUnder [Wireless func.], [Channel], etc., will be displayed.

6

7

Set [Channel].

Set the channel (1-4) to the same one as the slave unit.

Fire a test flash.

After checking that the slave unit is ready to fire, go to the screen in step 5 and press the <A> button.

XThe slave unit will fire. If it does not fire, check your settings again (p.123).

8 Take the picture.

Set the camera and take the picture as you would with normal flash shooting.

To terminate wireless flash shooting, set [Wireless func.] to [Disable].

Test flash can also be used to wake up slave units from auto power off. Setting [E-TTL II] to [Evaluative] is recommended.

If you use only one external Speedlite, the [Firing group] setting does not have any effect.

The slave unit is controlled by the built-in flash’s light pulse signal.

Wireless flash will not work if the [Flash mode] is set to [MULTI flash].

125