1 Using Full Auto

5 Take the picture.

¡ Compose the shot and press the

shutter button completely.

s The captured image will be displayed for about 2 sec. on the LCD monitor.

¡To view the images recorded on the CF card, press the <x> button. (p.107)

¡ While focusing with <AF>, do not touch the focusing ring at the front of the lens.

¡If you want to zoom, do it before focusing. Turning the zoom ring after achieving focus may throw off the focus.

¡When the CF card becomes full, the CF Full warning “FuLL CF” will appear in the viewfinder and on the LCD panel and shooting will be disabled. Replace the CF card with one that is not full.

¡If something obstructs the built-in flash from popping up, “Err 05” will blink on the LCD panel. If this happens, set the power switch to <2> and <1> again.

¡Using a non-Canon lens with an EOS camera may not result in proper camera or lens operation.

¡ When focus is achieved, the focus and exposure setting will also be locked.

¡If the focus confirmation light <o> blinks, the picture cannot be taken. (p.76)

¡The dot < . > in multiple AF points may flash in red at the same time. This indicates that focus has been achieved at all those AF points.

¡In the Basic Zone modes (except <3> <5> <7>), the built-in flash will pop up and fire automatically in low-light or backlit conditions. To retract the flash, push it back down.

¡You can disable the beeper from sounding when focus is achieved. Set the [zBeep] menu item. (p.50)

¡The image review time after image capture can be changed with the menu’s [xReview time] setting. (p.104)

¡If you want to freely select the AF point for focusing, set the Mode Dial to <d>, then follow “Selecting the AF Point” (p.73) to select the AF point.

45