NOTE

• After removing the jammed paper, check to see if the last page was scanned correctly, and then continue scanning.

• If a paper jam occurs when [Rapid recovery system] is enabled in the scanner driver setting screen, the image data of the document is not saved and operation is interrupted. This allows you to continue scanning from the document that caused the paper jam after the paper jam is fixed.

Contents

Back

 

Previous Page Next Page

7. Other Functions

Setting the Long Document Mode

The length of documents that can be scanned with the scanner is normally 14.02" (356 mm), but you can scan documents up to 39.2" (1000 mm) long by setting the scanner to the Long Document mode.

IMPORTANT

By selecting the Long Document mode and setting the [Paper Size] on the scanner driver settings screen to [Auto-detection], documents of up to 39.2" (1,000 mm) in length can be scanned. Note the following when using the Long Document mode:

•When scanning in the Long Document mode, if the document is placed on the scanner in a skewed position, it may hit the edges of the feeding area and be damaged. Be careful to place the document so that it is not skewed.

•When scanning with the Long Document mode, paper jam detection may react slowly, resulting in damage to the document. Be careful to avoid paper jams.

•When scanning long documents, make sure to set the feed selection lever to

(Bypass), and scan the documents one at a time.

Setting procedure under Windows

1Click the [Start] button → [Control Panel].

32